Digital Library: No conditions. Results ordered -Date Deposited. 2024-03-28T20:52:25ZEPrintshttp://digilib.unila.ac.id/images/sitelogo.pnghttp://digilib.unila.ac.id/2017-04-28T08:06:06Z2017-04-28T08:06:06Zhttp://digilib.unila.ac.id/id/eprint/26508This item is in the repository with the URL: http://digilib.unila.ac.id/id/eprint/265082017-04-28T08:06:06Z
MANAJEMEN INTERFERENSI DENGAN MENGGUNAKAN
POWER CONTROL UNTUK KOMUNIKASI DEVICE-TO-
DEVICE (D2D) DALAM JARINGAN KOMUNIASI SELULER
Peningkatan jumlah pengguna seluler secara signifikan menimbulkan
peningkatan kepadatan trafik komunikasi dalam jaringan selular, sehingga
diperlukan adanya penambahan kapasitas jaringan. Salah satu solusi untuk
menangani permasalahan tersebut ialah dengan menerapkan komunikasi Deviceto-Device
(D2D) dalam jaringan komunikasi seluler. Komunikasi D2D
merupakan sebuah fitur yang akan diterapkan pada teknologi Fifth Generation
(5G). D2D memungkinkan dua atau lebih perangkat telepon seluler yang
dilengkapi fitur D2D dapat berkomunikasi secara langsung tanpa melalui evolved
Node B (eNB) terlebih dahulu. Akan tetapi, penerapan komunikasi D2D dapat
menimbulkan interferensi terhadap komunikasi telepon seluler konvensional.
Pada skripsi ini, dilakukan pemodelan dan simulasi tentang manajemen
interferensi antara komunikasi D2D dan komunikasi telepon seluler dengan
menggunakan power control. Software yang digunakan untuk melakukan simulasi
adalah MATLAB. Tujuan dari simulasi yakni untuk mempertahankan Quality of
Service (QoS) jaringan. Parameter dari QoS yang digunakan dalam simulasi ini
adalah nilai Signal to Interference plus Noise Ratio (SINR), nilai Throughput, dan
nilai Bit Error Rate (BER).
Hasil simulasi menunjukkan bahwa penggunaan power control pada
simulasi terbukti mampu mengurangi pengaruh interferensi yang terjadi antara
komunikasi D2D dan komunikasi telepon seluler. Hal ini ditandai dengan
didapatkan nilai parameter QoS (SINR, Throughput, dan BER) pada simulasi
dengan menggunakan power control lebih mendekati nilai target bila
dibandingkan dengan simulasi tanpa menggunakan power control.
Kata Kunci: Device-to-Device (D2D), Komunikasi telepon selular, Power
Control, Signal to Interference plus Noise Ratio (SINR), Throughput, BER.
abstract
An increase in the number of cellular users significantly leads to high
communication traffic density in cellular network so that it requires additional
network capacity. One solution to mitigate this problem is to apply Device-toDevice
(D2D) Communication in cellular communication network. D2D
communication is a feature that will be applied to the Fifth Generation (5G)
technology. D2D allows two or more cellular devices with D2D features to
communicate directly without going through evolved Node B (eNB) first.
However, the application of D2D communication may cause interference to
conventional cellular phone communication.
In this undergraduate thesis, it was carried out the modeling and
simulation of interference management between D2D communication and cellular
communication using power control. The software used in the simulation is
MATLAB. The purpose of this simulation is to maintain the Quality of Service
(QoS) of the network. The parameters of QoS used in this simulation are the
values of Signal to Interference plus Noise Ratio (SINR), Throughput, and Bit
Error Rate (BER).
The simulation results show that the use of power control in the simulation
proved to reduce the interference effect that occurs between D2D communication
and cellular communication. It is indicated by the obtained QoS parameter values
(SINR, Throughput, and BER) in the simulation using power control closer to the
target value compared to the simulation without using power control.
Keywords: Device-to-Device (D2D), Cellular Communication, Power Control,
Signal to Interference plus Noise Ratio (SINR), Throughput, Bit Error Rate (BER) 1215031010 ANDRI ABADI andriabadi94@gmail.com